Concept Guide

Dell(conf)#%SYSTEM-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for user admin on
vty0 (10.11.9.209)
%SYSTEM-P:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable password
authentication success on vty0 ( 10.11.9.209 )
%SYSTEM-P:CP %SEC-5-LOGOUT: Exec session is terminated for user admin on line
vty0 (10.11.9.209)
Dell(conf)#username angeline password angeline
Dell(conf)#%SYSTEM-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for user angeline
on vty0 (10.11.9.209)
%SYSTEM-P:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable password
authentication success on vty0 ( 10.11.9.209 )
Monitoring TACACS+
To view information on TACACS+ transactions, use the following command.
● View TACACS+ transactions to troubleshoot problems.
EXEC Privilege mode
debug tacacs+
TACACS+ Remote Authentication and Authorization
The system takes the access class from the TACACS+ server. Access class is the class of service that restricts Telnet access
and packet sizes.
If you have configured remote authorization, the system ignores the access class you have configured for the VTY line and gets
this access class information from the TACACS+ server. The system must know the username and password of the incoming
user before it can fetch the access class from the server. A user, therefore, at least sees the login prompt. If the access class
denies the connection, the system closes the Telnet session immediately.
The following example demonstrates how to configure the access-class from a TACACS+ server. This configuration ignores the
configured access-class on the VTY line. If you have configured a deny10 ACL on the TACACS+ server, the system downloads
it and applies it. If the user is found to be coming from the 10.0.0.0 subnet, the system also immediately closes the Telnet
connection. Note, that no matter where the user is coming from, they see the login prompt.
When configuring a TACACS+ server host, you can set different communication parameters, such as the key password.
Example of Specifying a TACACS+ Server Host
Dell#
Dell(conf)#
Dell(conf)#ip access-list standard deny10
Dell(conf-std-nacl)#permit 10.0.0.0/8
Dell(conf-std-nacl)#deny any
Dell(conf)#
Dell(conf)#aaa authentication login tacacsmethod tacacs+
Dell(conf)#aaa authentication exec tacacsauthorization tacacs+
Dell(conf)#tacacs-server host 25.1.1.2 key Force10
Dell(conf)#
Dell(conf)#line vty 0 9
Dell(config-line-vty)#login authentication tacacsmethod
Dell(config-line-vty)#authorization exec tacauthor
Dell(config-line-vty)#
Dell(config-line-vty)#access-class deny10
Dell(config-line-vty)#end
Specifying a TACACS+ Server Host
To specify a TACACS+ server host and configure its communication parameters, use the following command.
● Enter the host name or IP address of the TACACS+ server host.
CONFIGURATION mode
tacacs-server host {hostname | ip-address} [port port-number] [timeout seconds] [key key]
Configure the optional communication parameters for the specific host:
○ port port-number: the range is from 0 to 65335. Enter a TCP port number. The default is 49.
Security
863