CLI Guide

● This feature is supported for IPv6 user ACLs only in the ingress direction.
● After using the feature ipv6acloptimized command on the system, reload the system for the
configuration to take effect.
Example
DellEMC(conf)# feature ipv6acloptimized
Configuration change will be in effect after save and reload. IPV6
Acls would be based on <= /64 Mask addresses only, Rules with mask
greater than 64 bits or host keyword will be rejected while applying on
interface.
DellEMC(conf)# cam-acl l2acl 0 ipv4acl 0 ipv6acl 8 ipv4qos 0 l2qos 0
l2pt 0 ipmacacl 1 vman-qos 0
DellEMC(conf)# reload
show cam-acl
Display the details of the CAM profiles on the chassis and all stack units.
Syntax
show cam-acl
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Updated to display IPv6 flow-based mirroring information on S5048F-ON, S6100–
ON, Z9100–ON, S6000, and S6000–ON. Updated to display the IPv6 ACL region in
multiples of 2 when the feature ipv6acloptimized command is enabled on
the S5048F–ON, S6100–ON, and Z9100–ON.
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series.
Usage
Information
The display reflects the settings implemented with the cam-acl command.
Example
Example (IPv6
flow-based
DellEMC#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
452 Content Addressable Memory (CAM)