CLI Guide

NOTE: For more information, refer to the Flow-based Monitoring section in
the Port Monitoring chapter of the FTOS Configuration Guide.
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command
History
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.11(2.0) Added the type parameter to filter the ICMP packets based on the type and code
on the S6000, S6000–ON, S6100–ON, Z9100–ON.
9.8(1.0) Introduced on the Z9100–ON..
9.8(0.0) Added the no-drop parameter.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the keyword dscp.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Added support for noncontiguous mask and added the monitor option.
6.5.10 Expanded to include the optional QoS order priority for the ACL entry.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more information, refer to
the Quality of Service chapter of the FTOS Configuration Guide.
When you use the log option, the CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
The monitor option is relevant in the context of flow-based monitoring only. For more information, refer
to Port Monitoring.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters may
display an incorrect value. Configure packet counters with logging instead.
permit tcp
To pass TCP packets meeting the filter criteria, configure a filter.
Syntax
permit tcp {source mask | any | host ip-address} [bit] [operator port
[port]] {destination mask | any | host ip-address} [bit] [ttl operator]
[dscp] [operator port [port]] [count [byte] [order] [fragments] [monitor]
[no-drop]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no permit tcp {source mask | any | host ip-address} {destination
mask | any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
Access Control Lists (ACL) 213