CLI Guide

peer-ovsdbserver-ip
Specify the IP address of the peer OVSDB server in a VLT setup.
Syntax
peer-ovsdbserver-ip peer-ip-address
To remove the configuration, use the no peer-ovsdbserver-ip
Parameters
peer-ip-address Enter the peer OVSDB server IP address. This is usually the management IP
address of the peer VLT device.
Defaults Not configured
Command Modes VXLAN-INSTANCE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S6000, S6000–ON, S6010-ON, S4048-ON, S4048T-ON,
S5048F-ON, S6100-ON, and Z9100-ON.
remote-vtep-ip
Create a remote VTEP and associate it to specified VNIDs.
Syntax
remote—vtep—ip IP Address vni-profile profile name
To delete the remote VTEP, use the no remote—vtep—ip command.
Parameters
IP Address Enter the IP Address of the remote VTEP.
vni-profile Enter the keyword vni-profile followed by the profile name to which the
remote VTEP has to be associated.
Defaults None.
Command Modes VXLAN-INSTANCE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.11(0.0) Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON,
and Z9100–ON.
Usage
Information
Use this command to associate a specific VNID to a remote VTEP. Provide a valid profile name while
associating to the remote VTEP.
NOTE: The remote VTEP IP Address cannot be any of the local IP Addresses configured in the
switch.
vnid
Associate a range of VNID numbers to a specific VNI profile.
Syntax
vnid VNID-Range
To remove the association, use the no vnid command.
1676 Virtual Extensible LAN (VXLAN)