CLI Guide

Example (all)
DellEMC#show environment
-- Fan Status --
Unit Bay TrayStatus Fan1 Speed Fan2 Speed
------------------------------------------------------------------------------------
1 1 up up 8295 up 8680
1 2 up up 8438 up 8548
1 3 up up 8456 up 8529
1 4 up up 8511 up 8529
Speed in RPM
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed Power AvgPower AvgPowerStartTime
--------------------------------------------------------------------------------------------
1 1 up AC up 9104 132 131 09/30/2017-05:18
1 2 down UNKNOWN down 0 0 0 N/A
-- Unit Environment Status --
Unit Status Temp Voltage
---------------------------------------------------------------------------
* 1 online 35C ok
* Management Unit
-- Thermal Sensor Readings (deg C) --
Unit Bcm_Int CpuOnBoard Bcm56967 SysInt0 SysInt1 Cpu_Int
---------------------------------------------------------------
1 51 35 37 21 28 36
show inventory
Display the switch type, components (including media), and Dell EMC Networking Operating System (OS), including hardware
identification numbers and configured protocols.
Syntax
show inventory [media slot]
Parameters
media slot (OPTIONAL) Enter the keyword media then the stack ID of the stack member for
which you want to display pluggable media inventory.
NOTE: This parameter is available but not supported in Dell EMC Networking
Operating System version 8.3.11.4. Because stacking is not supported, if you
use this parameter, the output displays “Media not present or accessible”
(refer to the Usage Information section).
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.11(0.0) Added support to display 10GBASE-T information on the S4048, S4048T, S6000,
S6000-ON, S6100, Z9500, S6010, and Z9100.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
124 Control and Monitoring