White Papers

Showing CAM PBR Configuration Example :
Dell#show cam pbr stack-unit 1 port-set 0
TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 - FIN
Cam Port VlanID Proto Tcp Src Dst SrcIp DstIp Next-hop Egress
Index Flag Port Port MAC Port
-----------------------------------------------------------------------------------------
------------------------
06080 0 N/A IP 0x0 0 0 200.200.200.200 200.200.200.200 199.199.199.199
199.199.199.199 N/A NA
06081 0 N/A TCP 0x10 0 40 234.234.234.234 255.234.234.234 222.222.222.222/24
00:00:00:00:00:09 8/1
Apply a Redirect-list to an Interface using a Redirect-
group
IP redirect lists are supported on physical interfaces as well as virtual local area network (VLAN) and port-channel interfaces.
NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop and the destination
port-channel is shut down, the traffic is dropped. However, the traffic redirected to the destination port-channel is
sometimes switched.
To apply a redirect list to an interface, use the following command. You can apply multiple redirect-lists can be applied to a
redirect-group. It is also possible to create two or more redirect-groups on one interface for backup purposes.
Apply a redirect list (policy-based routing) to an interface.
INTERFACE mode
ip redirect-group redirect-list-name test l2–switch
● redirect-list-name is the name of a redirect list to apply to this interface.
● FORMAT: up to 16 characters
● You can use the l2–switch option to apply the re-direct list to Layer2 traffic.
NOTE:
You can apply the l2–switch option to redirect Layer2 traffic only on a VLAN interface. This VLAN interface
must be configured with an IP address for ARP resolution. The Layer2 PBR option matches the layer2 traffic flow. If you
un-configure this option, then the Layer2 traffic is not matched.The Layer3 routing is not affected on the same interface
on which Layer2 PBR is applied. The port from which Layer2 packets egress and the destination MAC are re-written from
static ARP. Layer 2 packets with the re-written destination MAC are forwarded through the outgoing port on the same
incoming VLAN interface. The l2-switch option ensures that the outgoing VLAN and MAC-SA are changed and TTL is
not decremented.
To delete the redirect list from this interface, use the no ip redirect-group command.
In this example, the list xyz is applied to the 1/1 interface.
Example: Applying a Redirect-list to an Interface
Example: Applying a Redirect-list to an Interface
In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are supported on a single interface.
Dell EMC Networking OS has the capability to support multiple groups on an interface for backup purposes.
Show Redirect List Configuration
To view the configuration redirect list configuration, use the following commands.
1. View the redirect list configuration and the associated interfaces.
EXEC mode
show ip redirect-list redirect-list-name
2. View the redirect list entries programmed in the CAM.
560
Policy-based Routing (PBR)