White Papers

!
interface GigabitEthernet 9/7
no ip address
shutdown
!
interface GigabitEthernet 9/8
no ip address
shutdown
!
interface GigabitEthernet 9/9
no ip address
shutdown
Configuring the Default Interface
You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the
following steps:
1. View the configurations applied on an interface.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2. Reset the interface to the factory default state.
CONFIGURATION mode
default interface interface-type slot/port
Dell(conf)#default interface tengigabitethernet 1/5
3. Verify the configuration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.
Enabling a Physical Interface
After determining the type of physical interfaces available, to enable and configure the interfaces, enter INTERFACE mode by
using the interface interface slot/port command.
1. Enter the keyword interface then the type of interface and slot/port information.
CONFIGURATION mode
interface interface-type
● For the Management interface on the RPM, enter the keyword ManagementEthernet then the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
Interfaces
331