White Papers

neighbor {ip-address | peer-group-name} next-hop-self
● Sets the next hop address.
CONFIG-ROUTE-MAP mode
set next-hop ip-address
Changing the WEIGHT Attribute
To change how the WEIGHT attribute is used, enter the first command. You can also use route maps to change this and other
BGP attributes. For example, you can include the second command in a route map to specify the next hop address.
● Assign a weight to the neighbor connection.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | peer-group-name} weight weight
○ weight: the range is from 0 to 65535.
The default is 0.
● Sets weight for the route.
CONFIG-ROUTE-MAP mode
set weight weight
○ weight: the range is from 0 to 65535.
To view BGP configuration, use the show config command in CONFIGURATION ROUTER BGP mode or the show
running-config bgp command in EXEC Privilege mode.
Enabling Multipath
By default, the software allows one path to a destination. You can enable multipath to allow up to 16 parallel paths to a
destination.
To allow more than one path, use the following command.
The show ip bgp network command includes multipath information for that network.
● Enable multiple parallel paths.
CONFIG-ROUTER-BGP mode
maximum-paths {ebgp | ibgp} number
The show ip bgp network command includes multipath information for that network.
Filtering BGP Routes
Filtering routes allows you to implement BGP policies.
You can use either IP prefix lists, route maps, AS-PATH ACLs or IP community lists (using a route map) to control which routes
the BGP neighbor or peer group accepts and advertises. Prefix lists filter routes based on route and prefix length, while AS-Path
ACLs filter routes based on the ASN. Route maps can filter and set conditions, change attributes, and assign update policies.
NOTE: The Dell Networking OS supports up to 255 characters in a set community statement inside a route map.
NOTE: With the Dell Networking OS, you can create inbound and outbound policies. Each of the commands used for
filtering has in and out parameters that you must apply. In the system, the order of preference varies depending on
whether the attributes are applied for inbound updates or outbound updates.
For inbound and outbound updates the order of preference is:
● prefix lists (using the neighbor distribute-list command)
● AS-PATH ACLs (using the neighbor filter-list command)
● route maps (using the neighbor route-map command)
Prior to filtering BGP routes, create the prefix list, AS-PATH ACL, or route map.
For configuration information about prefix lists, AS-PATH ACLs, and route maps, refer to Access Control Lists (ACLs).
190
Border Gateway Protocol IPv4 (BGPv4)