Users Guide

00:17:38: %STKUNIT1-M:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable authentication
success on console
00:17:38: %STKUNIT1-M:CP %SEC-4-ENABLE_PASSW_NOT_CONFIGURED: Enable password is required
for authentication but not configured (by default from console)
00:00:22: %STKUNIT1-M:CP %SEC-5-LOGIN_SUCCESS: Login successful on console
00:00:20: %STKUNIT1-M:CP %IFMGR-5-OSTATE_UP: Changed interface state to up: Ma 1/1
00:00:20: %STKUNIT1-M:CP %CHMGR-2-SYSTEM_READY: System ready
To view any changes made, use the show running-config logging command in EXEC privilege mode.
Configuring a UNIX Logging Facility Level
You can save system log messages with a UNIX system logging facility.
To configure a UNIX logging facility level, use the following command.
● Specify one of the following parameters.
CONFIGURATION mode
logging facility [facility-type]
○ auth (for authorization messages)
○ cron (for system scheduler messages)
○ daemon (for system daemons)
○ kern (for kernel messages)
○ local0 (for local use)
○ local1 (for local use)
○ local2 (for local use)
○ local3 (for local use)
○ local4 (for local use)
○ local5 (for local use)
○ local6 (for local use)
○ local7 (for local use)
○ lpr (for line printer system messages)
○ mail (for mail system messages)
○ news (for USENET news messages)
○ sys9 (system use)
○ sys10 (system use)
○ sys11 (system use)
○ sys12 (system use)
○ sys13 (system use)
○ sys14 (system use)
○ syslog (for syslog messages)
○ user (for user programs)
○ uucp (UNIX to UNIX copy protocol)
To view nondefault settings, use the show running-config logging command in EXEC mode.
DellEMC#show running-config logging
!
logging buffered 524288 debugging
service timestamps log datetime msec
service timestamps debug datetime msec
!
logging trap debugging
logging facility user
logging source-interface Loopback 0
logging 10.10.10.4
DellEMC#
Management
69