Users Guide

bbdd96e6eb4828e2e27bc3f9ff541e43faa759c9ef5706ba10345a1039ba8f8a
Transform set : esp-128-aes esp-sha1-hmac
The following example shows the show crypto ipsec sa ipv6 command.
DellEMC#show crypto ipsec sa ipv6
Interface: TenGigabitEthernet 1/1/1
Link Local address: fe80::201:e8ff:fe40:4d10
IPSecv6 policy name: OSPFv3-1-500
inbound ah sas
spi : 500 (0x1f4)
transform : ah-md5-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
outbound ah sas
spi : 500 (0x1f4)
transform : ah-md5-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
inbound esp sas
outbound esp sas
Interface: TenGigabitEthernet 1/2/1
Link Local address: fe80::201:e8ff:fe40:4d11
IPSecv6 policy name: OSPFv3-1-600
inbound ah sas
outbound ah sas
inbound esp sas
spi : 600 (0x258)
transform : esp-des esp-sha1-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
outbound esp sas
spi : 600 (0x258)
transform : esp-des esp-sha1-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
Troubleshooting OSPFv3
The system provides several tools to troubleshoot OSPFv3 operation on the switch. This section describes typical, OSPFv3
troubleshooting scenarios.
NOTE:
The following troubleshooting section is meant to be a comprehensive list, but only to provide some examples of
typical troubleshooting checks.
● Have you enabled OSPF globally?
● Is the OSPF process active on the interface?
● Are the adjacencies established correctly?
● Did you configure the interfaces for Layer 3 correctly?
● Is the router in the correct area type?
● Did you include the routes in the OSPF database?
● Did you include the OSPF routes in the routing table (not just the OSPF database)?
Some useful troubleshooting commands are:
634
Open Shortest Path First (OSPFv2 and OSPFv3)