Users Guide

nlbclusteracl: 0 0
DellEMC#
NOTE: If you change the cam-acl setting from CONFIGURATION mode, the output of this command does not reflect any
changes until you save the running-configuration and reload the chassis.
Example of Viewing CAM-ACL Settings
DellEMC#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 2
L2PT : 0
IpMacAcl : 1
VmanQos : 0
EtsAcl : 0
FcoeAcl : 0
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
nlbclusteracl: 0
-- stack-unit 1 --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 2
L2PT : 0
IpMacAcl : 1
VmanQos : 0
EtsAcl : 0
FcoeAcl : 0
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
nlbclusteracl: 0
View CAM Usage
View the amount of CAM space available, used, and remaining in each partition (including IPv4 and IPv6 Flow and Layer 2 ACL
sub-partitions) using the show cam-usage command in EXEC Privilege mode
The following output shows CAM blocks usage for Layer 2 and Layer 3 ACLs and other processes that use CAM space:
Starting from OS 9.11(2.0), ACL filters are optimized to support more than 200 egress ACL rules on the S6000, S6000–ON,
S6100–ON, and Z9100–ON.
Example of the show cam-usage Command
DellEMC#show cam-usage
Stackunit|Portpipe|Pipeline| CAM Partition | Total CAM | Used CAM |Available CAM
========|========|========|=================|=============|=============|==============
1 | 0 | 0 | IN-L2 ACL | 0 | 0 | 0
| | | IN-L3 ACL | 512 | 1 | 511
| | | IN-L3 ECMP GRP | 2048 | 0 | 2048
| | | IN-V6 ACL | 256 | 0 | 256
| | | IN-NLB ACL | 0 | 0 | 0
| | | IPMAC ACL | 256 | 0 | 256
| | | IN-L3-UDFMIRRACL| 256 | 3 | 253
(IN-V6-MIRR ACL)
234
Content Addressable Memory (CAM)