Users Guide

To facilitate it’s working in a VLT environment, the loopback port channel should be provisioned as VLT port channels with a
peering relationship. For instance, in the topology below , P2 in VTEP 1 should be a VLT port-channel with it’s corresponding vlt-
peer-lag being P2 on VTEP 2, and similarly P6, etc., :
For VLT, in addition to the masks specified earlier, the VLT specific mask, to disallow frames that ingress on an ICL from going
out of a VLT port channel would be permanently in place. These masks won’t be removed for the loopback ports even if the VLT
peer LAG goes down (this is a deviation from standard VLT behavior, when these loopbacks are provisioned as VLT port-
channels.).
NSX Controller-based VXLAN for VLT
Apart from static VXLAN for VLT, you can also use an NSX controller for VXLAN in a VLT setup. The following illustration
depicts a VXLAN setup in a VLT topology. With this setup, VXLAN switch happens across data centers.
Virtual Extensible LAN (VXLAN)
1039