Setup Guide

Parameters
msti instance Enter the MSTP instance. The range is from zero (0) to 63.
vlan range Enter the keyword vlan then the identifier range value. The range is from 1 to
4094.
bridge-priority
priority
Enter the keywords bridge-priority then a value in increments of 4096 as the
bridge priority. The range is from zero (0) to 61440.
Valid priority values are: 0, 4096, 8192, 12288, 16384, 20480, 24576, 28672, 32768,
36864, 40960, 45056, 49152, 53248, 57344, and 61440. All other values are
rejected.
Defaults default bridge-priority is 32768.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced.
Usage
Information
By default, all VLANs are mapped to MST instance zero (0) unless you use the vlan range command
to map it to a non-zero instance.
name
The name you assign to the multiple spanning tree region.
Syntax
name region-name
To remove the region name, use the no name command.
Parameters
region-name Enter the MST region name. The range is 32 character limit.
Defaults No default name.
Command Modes MULTIPLE SPANNING TREE
902 Multiple Spanning Tree Protocol (MSTP)