Setup Guide

Field Description
● N2 = OSPF NSSA external type 2
● E1 = OSPF external type 1
● E2 = OSPF external type 2
● i = IS-IS
● L1 = IS-IS level-1
● L2 = IS-IS level-2
● IA = IS-IS inter-area
● * = candidate default
● > = non-active route
● + = summary routes
The weight for weighted ECMP route calculations is displayed for each path in
the route in show ip route command. The ECMP weight is displayed only if
weighted ECMP is enabled using the ip ecmp weighted command is enabled.
If weighted ECMP is disabled, the show ip route command does not show the
weighted ECMP route information.
Destination Identifies the route’s destination IP address
Gateway Identifies whether the route is directly connected and on which interface the route
is configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
Example
Example
(Summary)
Example (vrf)
Example (With
Weighted ECMP
Enabled)
Example (With
Weighted ECMP
Disabled)
show ip route list
Display IP routes in an IP prefix list.
Syntax
show ip route [vrf vrf-name] list prefix-list
Parameters
prefix-list Enter the name of a configured prefix list.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to display IP routes in an
IP prefix list corresponding to that VRF.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
718 IPv4 Routing