Setup Guide

Field Description
Input 0 IP
packets...
Displays the number of packets with IP headers, VLAN tagged headers, and MPLS
headers. The number of packets may not add correctly because a VLAN tagged IP
packet counts as both a VLAN packet and an IP packet.
0 64-byte... Displays the size of packets and the number of those packets entering that
interface. This information is displayed over two lines.
Received 0... Displays the type and number of errors or other specific packets received. This
information is displayed over three lines.
Output 0... Displays the type and number of packets sent out the interface. This information is
displayed over three lines.
Rate
information...
Displays the traffic rate information into and out of the interface. Traffic rate is
displayed in bits and packets per second.
Time since... Displays the time since the last change in the configuration of this interface.
Example
User Information The following describes the show interfaces port-channel brief command shown in the
following example.
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
● L3 — for Layer 3
● L2 — for Layer 2
Status Displays the status of the port channel.
● down — if the port channel is disabled (shutdown)
● up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
● In Layer 2 port channels, an * (asterisk) indicates which interface is the primary
port of the port channel. The primary port sends out interface PDU.
● In Layer 3 port channels, the primary port is not indicated.
Example
Related
Commands
● show lacp — display the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {source-mac address destination-mac address
{vlan vlanid | ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port
channel to display flow information.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Interfaces 661