Setup Guide

Version Description
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
● interface ManagementEthernet — configure the Management port on the system (either the Primary
or Standby RPM).
● management route — configure a static route that points to the Management interface or a
forwarding router.
stack-unit portmode
Syntax
Parameters
stack-unit Enter the stack member unit identifier of the stack member to reset.
number Enter the port number of the port to be split.
port Enter the keyword port then the port number to specify the port where fanout
mode is specified.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.7(0.0) Added support for dynamically fanning-out of interfaces on S6000. Introduced on
the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Usage
Information
The port must be in a default configuration before it can be split. As the 40G port is lost in the
configuration when the port is split, ensure that you remove the port from other L2/L3 feature
configurations.
You cannot use this command if you use an LR4 optics.
Example (stack
unit – Warning
message when
13 ports are
configured in any
port range)
DellEMC(conf)# stack-unit 0 port 48 portmode quad
Maximum number of ports that can be made Quad mode in the range <0-63>
is configured. Ports 52,56,60, will be disabled on reload.
Do you wish to continue? [confirm yes/no]:yes
Please save and reset unit 0 for the changes to take effect.
DellEMC(conf)#
652 Interfaces