Setup Guide

● The number of state change counters
Usage
Information
Executing this command without the optional ring-id command clears the statistics counters on all the
available rings. Dell EMC Networking OS requires a command line confirmation before the command is
executed. This command clears the following counters:
● hello Rx and Tx counters
● Topology change Rx and Tx counters
● The number of state change counters
Example
(Summary)
DellEMC# show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
----------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
DellEMC#
Example (1)
Example (1)
Example (2
Summary)
DellEMC# show frrp 2 summary
DellEMC#show frrp 2 summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------
2 Up Master 2 11-20, 25, 27-30
DellEMC#
Related
Commands
● protocol frrp — enter the resilient ring protocol and designate a ring identification.
timer
Set the hello interval or dead interval for the Ring control packets.
Syntax
timer {hello-interval milliseconds}| {dead-interval milliseconds}
To remove the timer, use the no timer {hello-interval [milliseconds]}| {dead-
interval milliseconds} command.
Parameters
hello-interval
milliseconds
Enter the keyword hello-interval then the time, in milliseconds, to set
the hello interval of the control packets. The milliseconds must be entered in
increments of 50 millisecond; for example, 50, 100, 150, and so on. If an invalid
value is entered, an error message is generated. The range is from 50 to 2000 ms.
Default: 500 ms.
dead-interval
milliseconds
Enter the keyword dead-interval then the time, in milliseconds, to set the dead
interval of the control packets. The range is from 50 to 6000 ms. Default: 1500
ms.
NOTE: The configured dead interval must be at least three times the hello
interval.
Defaults
● 500 ms for hello-interval milliseconds
● 1500 ms for dead-intervalmilliseconds
Command Modes CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Force10 Resilient Ring Protocol (FRRP) 565