Setup Guide

Field Description
Local DCBX
Status: Protocol
State
Current operational state of the DCBX protocol: ACK or IN-SYNC.
Peer DCBX
Status: DCBX
Operational
Version
DCBX version advertised in Control TLVs received from the peer device.
Peer DCBX
Status: DCBX
Max Version
Supported
Highest DCBX version supported in Control TLVs received from the peer device.
Peer DCBX
Status: Sequence
Number
Sequence number transmitted in Control TLVs received from the peer device.
Peer DCBX
Status:
Acknowledgment
Number
Acknowledgement number transmitted in Control TLVs received from the peer
device.
Total DCBX
Frames
transmitted
Number of DCBX frames sent from the local port.
Total DCBX
Frames received
Number of DCBX frames received from the remote peer port.
Total DCBX
Frame errors
Number of DCBX frames with errors received.
Total DCBX
Frames
unrecognized
Number of unrecognizable DCBX frames received.
Example
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports that
support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
Syntax
dcb-map map-nameTo remove a DCB map from an ethernet interface, use the no dcb-map
command.
Parameters
map-name Enter a DCB map name. The maximum number of alphanumeric characters is 32.
Defaults None.
Command Modes CONFIGURATION
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
460 Data Center Bridging (DCB)