Setup Guide

Command Modes ROUTER BGP (conf-router_bgp_af)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
CAUTION: Dell EMC Networking recommends that you do not change the administrative
distance of internal routes. Changing the administrative distances may cause routing table
inconsistencies.
The higher the administrative distance assigned to a route means that your confidence in that route is
low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from
confederations are treated as internal BGP routes.
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
Syntax
show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6 unicast]
dampened-paths
Parameters
vrf vrf-name (OPTIONAL) Enter the keywords vrf and then the name of the VRF to view
routes that are affected by a specific community list corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
view information related only to ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 followed by the keyword unicast to view
information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
Border Gateway Protocol 423