Setup Guide

Line starting
with
Description
Adv rcvd:... Displays counters for the following:
● Adv rcvd displays the number of VRRP advertisements received on the
interface.
● Adv sent displays the number of VRRP advertisements sent on the interface.
● Bad pkts rcvd displays the number of invalid packets received on the interface.
Virtual MAC
address
Displays the virtual MAC address of the VRRP group.
Virtual IP
address
Displays the virtual IP address of the VRRP router to which the interface is
connected.
Tracking states... Displays information on the tracked interfaces or objects configured for a VRRP
group (track command), including:
● UP or DOWN state of the tracked interface or object (Up or Dn).
● Interface type and slot/port or object number, description, and time since the
last change in the state of the tracked object.
● Cost subtracted from the VRRP group priority if the state of the tracked
interface/object goes DOWN.
Example
vrrp-ipv6-group
Assign an interface to a VRRP group.
Syntax
vrrp-ipv6-group vrid
Parameters
vrid Enter the virtual-router ID number of the VRRP group. The VRID range is from 1 to
255.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.4.2.1 The range of valid VRID values on the E-Series when VRF microcode is loaded in
CAM changed from 1 to 15.
8.4.1.0 Introduced on the E-Series, C-Series, and S-Series.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
1608 Virtual Router Redundancy Protocol (VRRP)