Setup Guide

• xoff-state threshold polling-count
disable storm-control pfc
You can disable the PFC storm globally.
Syntax
disable
Parameters None
Defaults None
Command Modes CONFIGURATION (conf-storm-control-pfc)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Usage
Information
The disable command is used to disable the PFC storm feature globally. By default, PFC storm feature
is enabled on all the interfaces on which "storm-control pfc in queue-drop" configuration has been
applied.
Example Use the storm-control pfc command in the configuration mode to enter the 'storm-control-pfc'
configuration mode. The commands provisioned in this mode are applicable for all the interfaces that have
PFC storm enabled.
DellEMC(conf)#storm-control pfc
DellEMC(conf-storm-control-pfc)#disable
polling-interval
You can set the time interval to poll the queue depth and egress counters.
Syntax
polling—interval {interval in milli-seconds}
Parameters
interval in milli-
seconds
Enter the polling interval in milliseconds. The range is 200 to 1000. The interval
should be entered in multiples of 100. The default interval value is 100 milliseconds.
Defaults 100 milli-seconds
Command Modes CONFIGURATION (conf-storm-control-pfc)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Usage
Information
The polling—interval command is used to set the interval in milliseconds to poll the queue traffic
and egress counters. You can use the polling results to detect the inconsistencies in the PAUSE frames
received .
1444 Storm Control