Setup Guide

Starting with Dell EMC Networking OS version 7.8.1.0, you can run this command directly on the stack
standby unit (standby master) to reset the standby. You cannot reset any other unit from the standby
unit.
Example
Related
Commands
● reload – reboots Dell EMC Networking OS.
show redundancy
Display the current redundancy configuration (status of automatic reboot configuration on stack management unit).
Syntax
show redundancy
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
To modify your results, use the show redundancy [pipe] command, as follows:
● except — show only text that doesn not match a pattern.
● find — search for the first occurrence of a pattern.
● grep — show only text that matches a pattern.
● no-more — do not paginate the output.
● save — save the output to a file.
Example
show system stack-ports
Display information about the stacking ports on all switches in the stack.
Syntax
show system stack-ports [status | topology]
Parameters
status (OPTIONAL) Enter the keyword status to display the command output without
the Connection field.
topology (OPTIONAL) Enter the keyword topology to limit the table to just the Interface
and Connection fields.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
1438 Stacking