Setup Guide

Protocols
lacp Enter the LACP protocol
xstp Enter one of the following protocols: STP, RSTP, MSTP, PVST.
Defaults Not enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the members option.
reset stack-unit
Reset any designated stack member except the management unit (master unit).
Syntax
Parameters
stack-unit Enter the stack-unit number.
hard Reset the stack unit if the unit is in a problem state.
Defaults none
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the hard reset option.
Usage
Information
Resetting the management unit is not allowed, and an error message displays if you try to do so.
Resetting is a soft reboot, including flushing the forwarding tables.
Stacking 1437