Setup Guide

fortyGigE 1/1/1
(25::2, ff0e::225:1:2:2), uptime 00:09:54, expires 00:00:00,flags: CJ
RPF neighbor: fortyGigE 1/3/1, fe80::201:e8ff:fe00:6265
Outgoing interface list:
fortyGigE 1/1/1
(25::1, ff0e::226:1:2:1), uptime 00:09:54, expires 00:00:00,flags: CJ
RPF neighbor: fortyGigE 1/3/1, fe80::201:e8ff:fe00:6265
Outgoing interface list:
fortyGigE 1/1/1
Dell#
Related
Commands
clear ipv6 pim tib – clears the IPv6 PIM tree information base (TIB)
IPv6 PIM-Sparse Mode Commands
The following describes the IPv6 PIM-sparse mode (PIM-SM) commands.
clear ipv6 pim tib
Clear the IPv6 PIM multicast-routing database (tree information base—TIB).
Syntax
clear ipv6 pim [vrf vrf-name] tib [group-address]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure
this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
group-address (OPTIONAL) Enter the multicast group address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
Defaults none
Command Modes EXEC Privilege
Command
History
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON,
S3100, S6010-ON, S3048-ON, and C9010.
Related
Commands
show ipv6 pim tib – displays the IPv6 PIM tree information base (TIB)
debug ipv6 pim
Invoke IPv6 PIM debugging.
Syntax
debug ipv6 pim [vrf vrf-name] [bsr | events | group [group] | packet [in
| out] | register [group] | state | timer [assert | hello | joinprune |
register]]
To disable IPv6 PIM debugging, use the no debug ipv6 pim [vrf vrf-name] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view IP
PIM debugging messages corresponding to that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
PIM-Sparse Mode (PIM-SM) 1107