Setup Guide

packet (OPTIONAL) Enter the keyword packet to invoke debugging of IPv6 PIM packets.
register [ group ] (OPTIONAL) Enter the keyword register and optionally the group address to
invoke debugging of IPv6 PIM register messages for a particular group.
state (OPTIONAL) Enter the keyword state to view IPv6 PIM state changes.
timer [assert |
hello | joinprune |
register]
(OPTIONAL) Enter the keyword timer to view IPv6 PIM timers. Enter one of the
optional parameters:
● assert: to view the assertion timer
● hello: to view the IPv6 PIM neighbor keepalive timer
● joinprune: to view the expiry timer (join/prune timer)
● register: to view the register suppression timer
Defaults Disabled.
Command Modes EXEC Privilege
Command
History
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON,
S3100, S6010-ON, S3048-ON, and C9010.
ipv6 pim bsr-border
Define the border of IPv6 PIM domain by filtering inbound and outbound PIM-BSR messages per interface.
Syntax
ipv6 pim bsr-border
To return to the default value, use the no ipv6 pim bsr-border command.
Defaults Disabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
9.14(1.0) Introduced on the C9010, S3048–ON, S3100 Series, S4048–ON, S4048T–ON,
S6000–ON, S6010–ON, S6100–ON, Z9100–ON.
Usage
Information
This command is applied to the subsequent PIM-BSR. Existing BSR advertisements are cleaned up by
time-out.
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0
to 4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1098 PIM-Sparse Mode (PIM-SM)