Service Manual

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
● interface ManagementEthernet — configure the Management port on the system (either the Primary
or Standby RPM).
● management route — configure a static route that points to the Management interface or a
forwarding router.
stack-unit portmode
Convert a single 40G port into 4x10G ports in a 16x40G module and a single 100G port into 2x50G ports, 1x40G port, 4x25G
ports or 4x10G ports in an 8x100G module.
Syntax
stack-unit stack-unit-number port number portmode {dual speed 50G | quad
speed {25G | 10G} | single speed 40G} [no-confirm]
Parameters
stack-unit Enter the stack member unit identifier of the stack member to reset.
port Enter the keyword port then the port number to specify the port where fanout
mode is specified.
single Convert a single 100G port into one 40G port.
dual Split a single 100G port into two 50G ports.
quad Split a single 100G port into four 10G or four 25G ports or split a single 40G port
into four 10G ports
no-confirm (OPTIONAL) Enter the keywords no-confirm to reset any previous configuration
and apply the new configuration immediately. If you this option, the system does
not prompt you to confirm the deletion of any existing configuration.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
Interfaces 707