Service Manual

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell EMC Networking OS version 7.8.1.0, when you use a copper SFP2 module
with catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its speed
with the speed command. When you set the speed to 10 Mbps or 100 Mbps, you can also execute
the duplex command.
Related
Commands
● negotiation auto — enable or disables auto-negotiation on an interface.
encapsulation dot1q
Configures lite-subinterfaces.
Syntax
encapsulation dot1q vlan-id
To remove a previously configured lite-subinterface, use the no encapsulation dot1q vlan-id
command.
Parameters
dot1q vlan-id Enter the keyword dot1q followed by the VLAN ID to which the host belongs. The
range is from 1 to 4094. A lite subinterface is considered as a Layer 3 port property
and is synchronous with the existing rules of applying Layer 2 or Layer 3 properties
to an interface.
Command Modes
INTERFACE
Command
History
Version Description
9.12.1.0 Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.3.0.0 Introduced on the S6000.
9.2(1.0) Introduced on the Z9500.
Usage
Information
To enable routing of RRoCE packets, the VLAN ID is mapped to the default VLAN ID of 4095 and this
mapping is performed using VLAN translation. After VLAN translation, the RRoCE packets are considered
in the same manner as normal IP packets that received on L3 interface and routed in the egress direction.
650 Interfaces