Release Notes
Table Of Contents
- Dell EMC Networking S3100 Series Release Notes, OS Version 9.14(2.10)
- Document Revision History
- Requirements
- New Dell EMC Networking OS Version 9.14(2.10) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrade Instructions
- Support Resources
Upgrading the CPLD
The S3100 series with the Dell EMC Networking OS Version 9.14(2.10) requires System CPLD revision 24.
NOTE: If your CPLD revisions are higher than the ones shown here, DO NOT make any changes. If you have questions
regarding the CPLD revision, contact technical support:
Verify that a CPLD upgrade is required
Use the following command to identify the CPLD version:
DellEMC#show revision
-- Stack unit 1 --
S3124F SYSTEM CPLD : 24
DellEMC#
Use the following command to view CPLD version that is associated with the Dell EMC Networking OS image:
DellEMC#show os-version
RELEASE IMAGE INFORMATION :
---------------------------------------------------------------------
Platform Version Size ReleaseTime
S-Series:S3100 9.14(2.10) 50155103 May 18 2021 12:52:25
TARGET IMAGE INFORMATION :
---------------------------------------------------------------------
Type Version Target checksum
runtime 9.14(2.10) Control Processor passed
BOOT IMAGE INFORMATION :
---------------------------------------------------------------------
Type Version Target checksum
boot flash 5.2.1.6 Control Processor passed
FPGA IMAGE INFORMATION :
---------------------------------------------------------------------
Card FPGA Name Version
stack-unit 1 S3148 SYSTEM CPLD 24
PoE-CONTROLLER IMAGE INFORMATION
---------------------------------------------------------------------
Type Version
PoE Controller 2.65
DellEMC#
Upgrading the CPLD Image
NOTE:
The upgrade fpga-image stack-unit 1 booted command is hidden when using the FPGA Upgrade
feature in the CLI. However, it is a supported command and is accepted when entered as documented.
NOTE: Ensure that the uBoot version is 5.2.1.8 or above. You can verify this version using show system stack-unit 1
command.
To upgrade the CPLD image on S3100 Series, follow these steps:
1. Upgrade the CPLD image.
EXEC Privilege mode
upgrade fpga-image stack-unit <id> booted
DellEMC#upgrade fpga-image stack-unit 1 booted
Current information for the system:
========================================================================
12