Install Guide

DellEMC(config-ext-nacl)#permit tcp any any
DellEMC(config-ext-nacl)#deny icmp any any
DellEMC(config-ext-nacl)#permit 1.1.1.2
DellEMC(config-ext-nacl)#end
DellEMC#show ip accounting access-list
!
Extended Ingress IP access list abcd on tengigabitethernet 0/0
seq 5 permit tcp any any
seq 10 deny icmp any any
seq 15 permit 1.1.1.2
DellEMC#configure terminal
DellEMC(conf)#interface te 1/2
DellEMC(conf-if-te-1/2)#ip vrf forwarding blue
DellEMC(conf-if-te-1/2)#show config
!
interface TenGigabitEthernet 1/2
ip vrf forwarding blue
no ip address
shutdown
DellEMC(conf-if-te-1/2)#
DellEMC(conf-if-te-1/2)#
DellEMC(conf-if-te-1/2)#end
DellEMC#
Applying Egress Layer 3 ACLs (Control-Plane)
By default, packets originated from the system are not filtered by egress ACLs.
For example, if you initiate a ping session from the system and apply an egress ACL to block this type of traffic on the interface,
the ACL does not affect that ping traffic. The Control Plane Egress Layer 3 ACL feature enhances IP reachability debugging by
implementing control-plane ACLs for CPU-generated and CPU-forwarded traffic. Using permit rules with the count option, you
can track on a per-flow basis whether CPU-generated and CPU-forwarded packets were transmitted successfully.
1. Apply Egress ACLs to IPv4 system traffic.
CONFIGURATION mode
ip control-plane [egress filter]
2. Apply Egress ACLs to IPv6 system traffic.
CONFIGURATION mode
ipv6 control-plane [egress filter]
3. Create a Layer 3 ACL using permit rules with the count option to describe the desired CPU traffic.
CONFIG-NACL mode
permit ip {source mask | any | host ip-address} {destination mask | any | host ip-
address} count [monitor [session-id]]
Dell EMC Networking OS Behavior: Virtual router redundancy protocol (VRRP) hellos and internet group management
protocol (IGMP) packets are not affected when you enable egress ACL filtering for CPU traffic. Packets sent by the CPU with
the source address as the VRRP virtual IP address have the interface MAC address instead of VRRP virtual MAC address.
IP Prefix Lists
IP prefix lists control routing policy. An IP prefix list is a series of sequential filters that contain a matching criterion (examine
IP route prefix) and an action (permit or deny) to process routes. The filters are processed in sequence so that if a route prefix
does not match the criterion in the first filter, the second filter (if configured) is applied. When the route prefix matches a filter,
Dell EMC Networking OS drops or forwards the packet based on the filter’s designated action. If the route prefix does not
match any of the filters in the prefix list, the route is dropped (that is, implicit deny).
A route prefix is an IP address pattern that matches on bits within the IP address. The format of a route prefix is A.B.C.D/X
where A.B.C.D is a dotted-decimal address and /X is the number of bits that should be matched of the dotted decimal
address. For example, in 112.24.0.0/16, the first 16 bits of the address 112.24.0.0 match all addresses between 112.24.0.0 to
112.24.255.255.
Access Control Lists (ACLs)
121