Deployment Guide

intf-type cr1 autoneg
Enable Clause 73 autonegotiation on a 25G CR1 interface.
Syntax
intf-type cr1 autoneg
Defaults
To disable Clause 73 autonegotiation on a 25G CR1 interface, use the no intf-type cr1 autoneg
command.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the Z9100–ON.
Example
DellEMC(conf-if-tf-1/1/1)#intf-type cr1 autoneg
DellEMC(conf-if-tf-1/1/1)#no intf-type cr1 autoneg
intf-type cr2 autoneg
Enable Clause 73 autonegotiation on a 50G CR2 interface.
Syntax
intf-type cr2 autoneg
To disable Clause 73 autonegotiation on a 50G CR2 interface, use the no intf-type cr2 autoneg
command.
Defaults
Not configured
Command Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced on the Z9100–ON.
Example
DellEMC(conf-if-fi-1/1/1)#intf-type cr2 autoneg
DellEMC(conf-if-fi-1/1/1)#no intf-type cr2 autoneg
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled. To set the interface type as CR4 with autonegotiation disabled,
use the no intf-type cr4 autoneg command.
Syntax
intf-type cr4 autoneg
Defaults
Enabled on the 100G interfaces
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Interfaces 671