Deployment Guide

show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with priorities and bandwidth
allocation.
Syntax
show interface port-type slot/port[/subport] ets {summary | detail}
Parameters
port-type slot/
port[/subport]
ets
Enter the port-type slot and port ETS information. Enter the subport number if a
port is fanned-out into 10G ports.
{summary |
detail}
Enter the keyword summary for a summary list of results or enter the keyword
detail for a full list of results.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.9(0.0) Added support to display the interface configurations corresponding to a range of
ports.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Down status messages added.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Example
(Summary)
DellEMC#show int te 1/20/1 ets summary
Interface TenGigabitEthernet 1/20/1
Max Supported TC is 4
Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Admin is enabled
PG-grp Priority# BW-% BW-COMMITTED BW-PEAK TSA
% Rate(Mbps) Burst(KB) Rate(Mbps) Burst(KB)
----------------------------------------------------------------------------------
0 0,1,2,3,4,5,6,7 100 - - - - ETS
1 - - - - - -
2 - - - - - -
3 - - - - - -
4 - - - - - -
5 - - - - - -
6 - - - - - -
7 - - - - - -
15 - - - - - -
Remote Parameters :
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
484 Data Center Bridging (DCB)