Deployment Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

481

482

483

484

485

486

487

488

489

490

Table Of Contents

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S6100-ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON and Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.

Usage

Information

For ETS functioning, first assign the etsacl space using the cam-acl command.

DellEMC(conf)#cam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2 l2qos 0 l2pt

0 ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2

Commands

● dcb <ets | pfc> enable — enable priority flow control or enhanced transmission selection on interface.

clear ets counters

Clear all ETS TLV counters on an interface.

Syntax

clear ets counters port-type slot/port[/subport]

Parameters

port-type Enter the keywords port-type then the slot/port information. Enter the subport

number if a port is fanned-out into 10G ports.

Defaults None

Command Modes EXEC Privilege