White Papers

Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To enable RIP, assign a network address using the network command.
Example
Dell(conf)#router rip
Dell(conf-router_rip)#
Related
Commands
network — enables RIP.
show config
Display the changes you made to the RIP configuration. The default values are not shown.
Syntax
show config
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-router_rip)#show config
!
router rip
network 172.31.0.0
passive-interface TenGigabitEthernet 0/1
Dell(conf-router_rip)#
show ip rip database
Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address (OPTIONAL) Specify an IP address in dotted decimal format to view RIP
information on that network only. If you enter an IP address, also enter a mask
for that IP address.
mask (OPTIONAL) Specify a mask, in /network format, for the IP address.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip rip database command shown in the following example.
Routing Information Protocol (RIP) 985