White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

981

982

983

984

985

986

987

988

989

990

Table Of Contents

Usage

Information

You can enable an unlimited number of RIP networks.

RIP operates over interfaces configured with any address the network command specifies.

offset-list

Specify a number to add to the incoming or outgoing route metrics learned using RIP.

Syntax

offset-list prefix-list-name {in | out} offset [interface]

To delete an offset list, use the no offset-list prefix-list-name {in | out} offset

[interface] command.

Parameters

prefix-list-name

Enter the name of an established Prefix list to determine which incoming routes are

modified.

offset

Enter a number from zero (0) to 16 to be applied to the incoming route metric

matching the access list specified. If you set an offset value to zero (0), no action

is taken.

interface

(OPTIONAL) Enter the following keywords and slot/port or number information:

● For a Port Channel interface, enter the keywords port-channel then a

number. The range is from 1 to 128.

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

● For a VLAN, enter the keyword vlan then a number from 1 to 4094.

Defaults Not configured.

Command Modes ROUTER RIP

Supported Modes Full–Switch

Command

History

Version Description

9.9(0.0) Introduced on the FN IOM.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Usage

Information

When the offset metric is applied to an interface, that value takes precedence over an offset value that is

not extended to an interface.

Commands

ip prefix-list — enters PREFIX-LIST mode and configure a prefix list.

output-delay

Set the interpacket delay of successive packets to the same neighbor.

Syntax

output-delay delay

To return to the switch software defaults for interpacket delay, use the no output-delay command.