White Papers

Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To access this command, enter the class-map command. You can match against only one VLAN ID.
Related
Commands
class-map — identifies the class map.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policy map
(input/output) applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate qos-policy-name
command.
Parameters
qos-policy-name Enter the name of the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output)
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic. Aggregate input/
output QoS policy can coexist with per queue input/output QoS policies.
1. If only aggregate input QoS policy exists, input traffic conditioning configurations (rate-police) apply.
Any marking configurations in aggregate input QoS policy are ignored.
2. If aggregate input QoS policy and per class input QoS policy coexist, aggregate input QoS policy
preempts per class input QoS policy on input traffic conditioning (rate-police). In other words, if rate
police configuration exists in the aggregate QoS policy, the rate police configurations in per class QoS
are ignored. Marking configurations in per class input QoS policy still apply to each queue.
Related
Commands
policy-map-output — creates an output policy map.
policy-map-input
Create an input policy map.
Syntax
policy-map-input policy-map-name [layer2]
To remove an input policy map, use the no policy-map-input policy-map-name [layer2]
command.
Parameters
policy-map-name Enter the name of the policy map in character format (32 characters maximum).
Quality of Service (QoS) 953