White Papers

ip ssh rekey
Configures the time rekey-interval or volume rekey-limit threshold at which to re-generate the SSH key during an SSH session.
Syntax
ip ssh rekey [time rekey-interval] [volume rekey-limit]
To reset to the default, use no ip ssh rekey [time rekey-interval] [volume rekey-
limit] command.
Parameters
time minutes Enter the keywords time then the amount of time in minutes. The range is from 10
to 1440 minutes. The default is 60 minutes
volume rekey-
limit
Enter the keywords volume then the amount of volume in megabytes. The range is
from 1 to 4096 to megabytes. The default is 1024 megabytes
Defaults The default time is 60 minutes. The default volume is 1024 megabytes.
Command Modes CONFIGURATION mode
Supported Modes Full–Switch
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, MXL
match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
Syntax
match ip access-group access-group-name [set-ip-dscp value]
To remove ACL match criteria from a class map, use the no match ip access-group access-
group-name [set-ip-dscp value] command.
Parameters
access-group-
name
Enter the ACL name whose contents are used as the match criteria in determining
if packets belong to the class the class-map specifies.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The
matched traffic is marked with the DSCP value. The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM..
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To access this command, enter the class-map command. After the class map is identified, you can
configure the match criteria. For class-map match-any, a maximum of five ACL match criteria are allowed.
For class-map match-all, only one ACL match criteria is allowed.
Related
Commands
class-map — identifies the class map.
948 Quality of Service (QoS)