White Papers

monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/2
direction both
Dell#
Dell#show run monitor session 20
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/2
direction both
Dell#
Related
Commands
monitor session — creates a session for monitoring.
show monitor session — displays a monitor session.
source (port monitoring)
Configure a port monitor source.
Syntax
source interface destination interface direction {rx | tx | both}
To disable a monitor source, use the no source interface destination interface
direction {rx | tx | both} command.
Parameters
interface Enter the one of the following keywords and slot/port information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
destination Enter the keyword destination to indicate the interface destination.
direction {rx | tx
| both}
Enter the keyword direction followed by one of the packet directional
indicators.
● rx: to monitor receiving packets only.
● tx: to monitor transmitting packets only.
● both: to monitor both transmitting and receiving packets.
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Example
Dell(conf-mon-sess-11)#source tengig 0/1 destination tengig 0/8 direction
rx
Dell(conf-mon-sess-11)#
Usage
Information
The monitored (source) interface must be a server-facing interface in the format slot/port, where valid
slot number is 0 and server-facing port numbers are from 1 to 8.
Port Monitoring 921