White Papers

ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
Parameters
interface Enter the following keyword and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
● For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Related
Commands
telnet — telnets to another device.
ip ftp username
Assign a user name for outgoing FTP connection requests.
Syntax
ip ftp username username
Parameters
username Enter a text string as the user name up to 40 characters long.
Defaults No user name is configured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Configure a password with the ip ftp password command.
Related
Commands
ip ftp password — sets the password for FTP connections.
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set
the access conditions for the designated line.
Syntax
line {console 0 | vty number [end-number]}
Parameters
console 0 Enter the keyword console 0 to configure the console port.
92 Control and Monitoring