White Papers

To remove the description, use the no description {description} command.
Parameters
description Enter a description regarding this session (80 characters maximum).
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
erpm
Configure the source and destination IP address for ERPM traffic.
Syntax
erpm source-ip ip-address dest-ip ip-address [gre-protocol value]
To remove the configuration, use the no erpm source-ip IP-address dest-ip IP-address
[gre-protocol value] command.
Parameters
source–ip ip-
address
Enter the keywords source-ip then the source IP address in dotted decimal
format.
destination–ip
ip-address
Enter the keywords dest-ip then the destination IP address in dotted decimal
format.
gre–protocol
value
(OPTIONAL) Enter the keywords gre-protocol then the protocol type value for
ERPM type monitor session. The range is from 1 to 65535.
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Example
Dell(conf-mon-sess-10)#erpm source-ip 10.10.10.1 dest-ip 5.1.1.2 gre-
protocol 1111
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced GRE protocol support.
Related
Commands
● monitor session — creates a session for monitoring traffic with port monitoring.
● show monitor session — displays information about monitor configurations.
flow-based enable
Enable flow-based monitoring.
Syntax
flow-based enable
To disable flow-based monitoring, use the no flow-based enable command.
Defaults Disabled, that is flow-based monitoring is not applied.
Port Monitoring 917