White Papers

Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0
to 4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Supported Modes Full—Swtich
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The router with the largest value assigned to an interface becomes the designated router. If two
interfaces contain the same designated router priority value, the interface with the largest interface IP
address becomes the designated router.
ipv6 pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the PIM-SM router from
creating state based on multicast source and/or group.
Syntax
ipv6 pim join-filter access-list
Parameters
access-list Enter the name of an extended access list.
in Enter the keyword in to apply the access list to inbound traffic.
out Enter the keyword out to apply the access list to outbound traffic.
Defaults none
Command Modes INTERFACE
Supported Modes Full—Swtich
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf)#ipv6 access-list JOIN-FIL_ACL
Dell(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::225:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any
Dell(conf-ipv6-acl)#exit
Dell(conf)#interface tengigabitethernet 0/84
Dell(conf-if-te-0/84)#ipv6 pim join-filter JOIN-FIL_ACL in
Dell(conf-if-te-0/84)#ipv6 pim join-filter JOIN-FIL_ACL out
ipv6 pim query-interval
Change the frequency of IPv6 PIM router-query messages.
Syntax
ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds command.
Parameters
seconds Enter a number as the number of seconds between router query messages. The
range is from 0 to 65535. The default is 30 seconds.
PIM-Sparse Mode (PIM-SM) 909