White Papers

Flags:D- Dense, S- Sparse, C- Connected, L- Local, P- Pruned,
R- RP-bit set, F- Register flag, T- SPT-bit set, J- Join SPT,
M- MSDP created entry, A- Candidate for MSDP Advertisement,
K- Ack-Pending State
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, 226.1.1.1), uptime 01:29:19, expires 00:00:52, RP 10.211.2.1, flags:
SCJ
Incoming interface: TenGigabitEthernet 0/2, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 0/8
(*, 226.1.1.2), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags:
SCJ
Incoming interface: TenGigabitEthernet 1/2, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 0/8
(*, 226.1.1.3), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags:
SCJ
Incoming interface: TenGigabitEthernet 1/2, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 0/8
(*, 226.1.1.4), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags:
SCJ
Incoming interface: TenGigabitEthernet 1/2, RPF neighbor 10.211.1.2
Outgoing interface list:
TenGigabitEthernet 0/8
show running-config pim
Display the current configuration of PIM-SM snooping.
Syntax
show running-config pim
Command Modes EXEC Privilege
Supported Modes Full—Swtich
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show running-config pim
!
ip pim snooping enable
Related
Commands
ip pim sparse-mode — enables PIM-SM snooping.
IPv6 PIM-Sparse Mode Commands
The following describes the IPv6 PIM-sparse mode (PIM-SM) commands.
PIM-Sparse Mode (PIM-SM)
907