White Papers

Dell(config-std-nacl)#exit
Dell(conf)#int te 0/1
Dell(config-if-te-0/1)# ip pim ingress-interface-map map1
ip pim neighbor-filter
To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-list} command.
Parameters
access-list Enter the name of a standard access list. Maximum 16 characters.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full—Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Do not enter this command before creating the access-list.
ip pim query-interval
Change the frequency of PIM Router-Query messages.
Syntax
ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds command.
Parameters
seconds Enter a number as the number of seconds between router query messages. The
range is from 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Supported Modes Full—Swtich
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ip pim register-filter
To prevent a PIM source DR from sending register packets to an RP for the specified multicast source and group, use this
feature.
Syntax
ip pim register-filter access-list
To return to the default, use the no ip pim register-filter access-list command.
PIM-Sparse Mode (PIM-SM) 895