White Papers

• show ipv6 pim rp
• show ipv6 pim tib
IPv4 PIM-Sparse Mode Commands
The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.
clear ip pim rp-mapping
The bootstrap router (BSR) feature uses this command to remove all or particular rendezvous point (RP) advertisement.
Syntax
clear ip pim rp-mapping rp-address
Parameters
rp-address (OPTIONAL) Enter the RP address in dotted decimal format (A.B.C.D).
Command Modes EXEC Privilege
Supported Modes Full—Swtich
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
clear ip pim tib
Clear PIM tree information from the PIM database.
Syntax
clear ip pim tib [group]
Parameters
group (OPTIONAL) Enter the multicast group address in dotted decimal format (A.B.C.D).
Command Modes EXEC Privilege
Supported Modes Full—Swtich
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you use this command on a local VLT node, all multicast routes from the local PIM TIB, the entire
multicast route table, and all the entries in the data plane are deleted. The local VLT node sends a request
to the peer VLT node to download multicast routes learned by the peer. Both local and synced routes are
removed from the local VLT node multicast route table. The peer VLT node clears synced routes from the
node.
If you use this command on a peer VLT node, only the synced routes are deleted from the multicast route
table.
debug ip pim
View IP PIM debugging messages.
Syntax
debug ip pim [bsr | events | group | packet [in | out] | register | state |
timer [assert | hello | joinprune | register]]
PIM-Sparse Mode (PIM-SM) 891