Manualshelf

White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9
881882883884885886887888889890
Table Of Contents
● range = inclusive range of ports (you must specify two ports for the
portcommand parameter.)
Defaults none
Command Modes REDIRECT-LIST
Supported Modes Full—Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series TeraScale.
7.5.1.0 Introduced on the E-Series ExaScale.
redirect
Configure a rule for the redirect list.
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track <obj-id>]{ip-
protocol-number | protocol-type [bit]} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [operator]
To remove this filter, use one of the following:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● You can also use the no redirect {ip-address | slot/port}| tunnel tunnel-id}
[track <obj-id>]{ip-protocol-number [bit] | protocol-type} {source mask
| any | host ip-address} {destination mask | any | host ip-address}
[operator] command.
Parameters
ip-address
Enter the IP address of the forwarding router.
slot/port
Enter the keyword slot / port followed by the slot/port information.
ip-protocol-
number
Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
tunnel
Enter the keyword tunnel to configure the tunnel setting.
tunnel-id
Enter the keyword tunnel-id to redirect the traffic.
track
Enter the keyword track to enable the tracking.
track
<obj-id>
Enter the keyword track <obj-id> to track object-id.
protocol-type
Enter one of the following keywords as the protocol type:
● icmp for internet control message protocol
● ip for any internet protocol
● tcp for transmission control protocol
● udp for user datagram protocol
bit
(OPTIONAL) For the TCP protocol type only, enter one or a combination of the
following TCP flags:
● ack = acknowledgement
● fin = finish (no more data from the user)
● psh = push function
● rst = reset the connection
● syn = synchronize sequence number
● urg = urgent field
Policy-based Routing (PBR) 885