White Papers

Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL.
end
Return to EXEC Privilege mode from other command modes (for example, CONFIGURATION mode).
Syntax
end
Command Modes
● CONFIGURATION
● LINE
● INTERFACE
● MONITOR SESSION
● PROTOCOL LLDP
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Related
Commands
exit— returns to the lower command mode.
exec-timeout
Set a time interval that the system waits for input on a line before disconnecting the session.
Syntax
exec-timeout minutes [seconds]
To return to default settings, use the no exec-timeout command.
Parameters
minutes Enter the number of minutes of inactivity on the system before disconnecting the
current session. The range is from 0 to 35791. The default is 10 minutes for the
console line and 30 minutes for the VTY line.
seconds (OPTIONAL) Enter the number of seconds. The range is from 0 to 2147483. The
default is 0 seconds.
Defaults 10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command Modes LINE
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To remove the time interval, use the exec-timeout 0 0 command.
86 Control and Monitoring