White Papers

Command Modes
● CONFIGURATION
● INTERFACE
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following commands are not supported by the do command:
● enable
● disable
● exit
● config
Example
Dell(conf-if-te-3/1)#do clear counters
Clear counters on all interfaces [confirm]
Dell(conf-if-te-3/1)#
Dell(conf-if-te-3/1)#do clear logging
Clear logging buffer [confirm]
Dell(conf-if-te-3/1)#
Dell(conf-if-te-3/1)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
Dell(conf-if-te-3/1)#
enable
Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may need to enter a
password.
Syntax
enable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of the Dell Networking OS. The
range is from 0 to 15. The default is 15.
Defaults 15
Command Modes EXEC
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
Users entering EXEC Privilege mode or any other configured privilege level can access configuration
commands. To protect against unauthorized access, use the enable password command to configure
a password for the enable command at a specific privilege level. If no privilege level is specified, the
default is privilege level 15.
Related
Commands
enable password — configures a password for the enable command and to access a privilege level.
84 Control and Monitoring