White Papers

Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Added support for OSPFv3.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
mib-binding
Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.
Syntax
mib-binding
To mib-binding on this OSPF process, use the no mib-binding command.
Defaults none.
Command Modes ROUTER OSPF
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the first
OSPF process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB
responsibility.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal format. The primary
address is required before adding the secondary address.
mask Enter a network mask in /prefix format. (/x)
area-id Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal
value range is from 0 to 65535. IP address format is dotted decimal format
A.B.C.D.
NOTE: If the area ID is smaller than 65535, it is converted to a decimal value.
For example, if you use an area ID of 0.0.0.1, it is converted to 1.
Command Modes ROUTER OSPF
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
830 Open Shortest Path First (OSPFv2 and OSPFv3)