White Papers

fcoe-map — creates an FCoE map which contains the parameters used in the communication between
servers and a SAN fabric.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the specified map.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN I/O Aggregator.
9.6(0.0) Supported on the M I/O Aggregator.
Usage
Information
Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and
priority-based flow control (PFC) parameters used to configure server-facing Ethernet ports.
The following table describes the show qos dcb-map output shown in the example below.
Field Description
State Complete: All mandatory DCB parameters are correctly configured. In progress:
The DCB map configuration is not complete. Some mandatory parameters are not
configured.
PFC Mode PFC configuration in DCB map: On (enabled) or Off.
PG Priority group configured in the DCB map.
TSA Transmission scheduling algorithm used by the priority group: Enhanced
Transmission Selection (ETS).
BW Percentage of bandwidth allocated to the priority group.
PFC PFC setting for the priority group: On (enabled) or Off.
Priorities 802.1p priorities configured in the priority group.
Example
Dell# show qos dcb-map dcbmap2
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 4 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
NPIV Proxy Gateway 809