White Papers

Use the dcb-map command to create a DCB map to specify PFC and ETS settings and apply it on
Ethernet ports. After you apply a DCB map to an interface, the PFC and ETS settings in the map are
applied when the Ethernet port is enabled. DCBx is enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name command in Interface
configuration mode.
Related
Commands
show qos dcb-map– displays the dcb-map profiles configured on the system.
dcb-map stack-unit all stack-ports all– applies a DCB map on all ports of a switch stack.
description (for FCoE maps)
In an FCoE map, add a text description of the FCoE and FC parameters used to transmit storage traffic over an FN 2210S
Aggregator and M I/O Aggregator NPIV proxy gateway in a converged fabric.
Syntax
description text
Parameters
text Enter a maximum of 32 characters.
Defaults None
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage
Information
The text description is displayed in show fcoe-map command output.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between
servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE maps.
fabric-id vlan
In an FCoE map, configure the association between the dedicated VLAN used to carry FCoE traffic between servers and a SAN,
and the fabric where the desired storage arrays are installed.
Syntax
fabric-id fabric-num vlan vlan-id
Parameters
fabric-id fabric-
num
Enter a fabric ID number that is the same as the ID number of the dedicated VLAN
used to carry FCoE storage traffic to the fabric specified in the FCoE map. You can
enter a fabric ID in the range 2–4094.
vlan vlan-id Enter the ID number of the dedicated VLAN used to carry FCoE storage traffic
between servers and a SAN fabric and specified with the vlan command in the
FCoE map.
Defaults None
Command Modes FCOE MAP
NPIV Proxy Gateway 799