White Papers

Multicast
The multicast commands are supported by Dell Networking Operating System (OS).
This chapter contains the following sections:
● IPv4 Multicast Commands
● IPv6 Multicast Commands
Topics:
• IPv4 Multicast Commands
• clear ip mroute
• ip mroute
• ip multicast-limit
• ip multicast-routing
• mtrace
• show ip mroute
• show ip rpf
• IPv6 Multicast Commands
• debug ipv6 mld_host
• ip multicast-limit
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree
information base, use the clear ip pim tib command.
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[ source-address ]
Enter the multicast group address and source address (if desired), in dotted
decimal format, to clear information on a specific group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping route table entries.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2.(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
show ip pim tib — shows the PIM tree information base.
39
Multicast 787